A distributor in the Ford 5.0 transfers electrical current to the spark plugs in a specific sequence. If the present arrives at the plug out of sequence, the spark plug will attempt to fire when there is nothing to ignite within the cylinders. This may cause harm to the engine. It’s important that the distributor be in correct working order, and that the engine is timed properly for the combustion process to work properly. It does not take very lengthy to install a distributor. You are able to do this your self, so there is no have to take the Ford to a restore garage.
Ford 5.0L Distributor Installation Instructions
1. Open the engine compartment on the Ford and safe it using the prop rod. Disconnect the negative cable from the battery utilizing a wrench to loosen the nut on the terminal.
2. Label every of the spark plug wires using the marker and masking tape. Pull every plug wire from the distributor cap by grasping the boot and pulling the wire off. Don’t pull it by the wire itself or you will injury the filament in the wire.
3. Disconnect the wire from the ignition coil by pulling it off. Remove the retaining screws from the distributor cap with the screwdriver. Pull the cap away from the distributor by pulling it straight up. Pull the rotor button from the shaft of the distributor. Take away the distributor retaining bolts utilizing a wrench.
4. Remove the distributor from the engine. Place the brand new distributor on the engine and secure the mounting bolts with a wrench. Set up the rotor button on the shaft. Install the rotor cap and tighten the retaining screws with a screwdriver.
5. Exchange the spark plug wires on the distributor in keeping with the labels you made when eradicating them. Push every wire in till you feel it snap into place. Join the destructive battery cable and tighten the terminal nut utilizing a wrench.