Installing the spark plug wires on your Ford engine is not a lot different from putting in plug wires on any engine, with the exception that the distributor is situated in the front of some Ford V8 engines. If your spark plug wires aren’t functioning appropriately, your engine will not run effectively since the spark is not correctly traveling from the distributor to the engine.
Ford Spark Plug Wires Installation Instructions
1. Allow your engine to cool not less than 1 or 2 hours, until you may safely contact the exhaust manifolds.
2. Decide a wire on the distributor where you wish to remove and install a new spark plug wire. Pull the boot of the wire off the distributor cap by gripping the boot the place the boot meets the wire, and pulling the cable back.
3. Hold the wire in a single hand, and pull it out of any spark plug wire clips utilizing your fingers and pull till you get to the spark plug on the different end. Grip the spark plug wire boot in the same method as in Step 1, and pull the boot off the spark plug.
4. Set up the replacement wire onto the distributor cap by putting the boot onto the electrode on the distributor and pushing it in place until the boot makes a popping sound.
5. Run the substitute wire alongside the trail left empty by the wire you eliminated in Step 2, and push the spark plug wire boot onto the spark plug until it pops into place.
6. Repeat Steps 1 by way of four for every plug wire on the engine (in order not to cross your spark plug wires and get them confused).